blocked

Author Topic: MICRO-D Rebuildable Dripping Atomiser  (Read 881 times)

andypandy

  • Full Member
  • ***
  • Posts: 64
  • Liked: 13
  • Likes Given: 8
MICRO-D Rebuildable Dripping Atomiser
« on: March 18, 2015, 10:56:18 AM »
Had this a day, spend yesterday umming and ahhing, wasn't sure at all, it's so tiny.Tried fitting the 3 supplied coils, messed them up. made a little one this morning, 1.39 ohm, I think using  kanthal A1 30awg, it was just a bit of spare wire I had floating around.  Managed to wick it ok with C9V CelluCotton. It's real scary because you could quite easily short the coil out on the metal body and I was expecting single coil (2 posts) not dual (3 posts), hence there is not much room insideesp. as the whole is so small to start with.

In a state of absolute anxiety I fired it up, no explosions, just  fantastic flavour  :thumbs:

The flavour beats both of my main tanks which are the Nautilus and the Lemo.  Next up dual coil it and try that, I'm gonna be getting right into this dripping lark  :dance:


Carol_Scot

  • Forum Host
  • Super Member
  • *****
  • Posts: 6459
  • NAME YOUR PV {{ HAPPY VAPING }}
  • Liked: 933
  • Likes Given: 3799
Re: MICRO-D Rebuildable Dripping Atomiser
« Reply #1 on: March 18, 2015, 08:31:43 PM »
Andy theres a Dripping Thread
you may get lots of info in there :)
 
http://www.c9v-forum.com/general-vaping-discussions/the-direct-dripping-thread-1738/?topicseen

carol
BILLETBOX's V1.1  :) Dingo , iTaste V3  , Provari Mini V2 & Prive Tank

andypandy

  • Full Member
  • ***
  • Posts: 64
  • Liked: 13
  • Likes Given: 8
Re: MICRO-D Rebuildable Dripping Atomiser
« Reply #2 on: March 20, 2015, 03:09:06 PM »
Thanks a lot Carol  :thumbs:

Carol_Scot

  • Forum Host
  • Super Member
  • *****
  • Posts: 6459
  • NAME YOUR PV {{ HAPPY VAPING }}
  • Liked: 933
  • Likes Given: 3799
Re: MICRO-D Rebuildable Dripping Atomiser
« Reply #3 on: March 20, 2015, 04:55:37 PM »
Your welcome :)
BILLETBOX's V1.1  :) Dingo , iTaste V3  , Provari Mini V2 & Prive Tank